 Bow pole running
rigging. The pole is
pulled up by a light line to the deck cleat, and held down by a piece of covered Amsteel. |
 First attempt at
positioning the net support
poles. I won't attach them permanently until I have unfolded the boat in the water and measured exactly where they should go. |
 New aft mast
support to
replace the one made from 2x4s. |
 Positioning
the
support tubes' sleeves in the
transom. There are holes drilled through the bottom of the boat to drain the tubes. After mounting the tubes I filled the bottoms with epoxy and re-drilled the holes. |
 The mast support
tubes sit on bolts through
the sleeves, so they won't wear away at the glass at the bottom of the tubes. |
 |
 Sep 18 2006 8:53:42 pm |
 Sep 18 2006 8:53:50 pm |
 The third, and
hopefully final, incarnation
of the "halyard catcher" at the end of the mast raising pole. |
 The retired
original mast support.
|
 Sep 21 2006 7:31:27 pm |
 Foot-long arms with
plenty of glass.
|